Bienvenue sur GM3800Québec Index du Forum

Bienvenue sur GM3800Québec

 FAQFAQ   RechercherRechercher   MembresMembres   GroupesGroupes   S’enregistrerS’enregistrer 
 ProfilProfil   Se connecter pour vérifier ses messages privésSe connecter pour vérifier ses messages privés   ConnexionConnexion 

Changer filtre et huile à moteur

Poster un nouveau sujet   Répondre au sujet    Bienvenue sur GM3800Québec Index du Forum -> Discussion automobile -> Comment faire "How-To" & Infos -> How-To - Comment faire
Sujet précédent :: Sujet suivant  
Auteur Message

Hors ligne

Inscrit le: 14 Nov 2010
Messages: 1 216
Localisation: Valleyfield

MessagePosté le: Mer 3 Juil - 06:50 (2013)    Sujet du message: Changer filtre et huile à moteur Répondre en citant

Pontiac Grand Prix Engine Oil Change Guide
A pictures illustrated, step by step instruction manual for changing the motor oil in the GM 3800 L67 S/C V6 engine.
Main Menu                 Home                Digital Cameras                Misc. Pictures                 Articles                 My Blog  

Disclaimer - I am not a mechanic. Consult your owner's manual or dealer if you have any doubts. I claim no responsibility for damage to your vehicle.

Pontiac Grand Prix GTP

GM 3800 V6 Supercharged

Used Oil Catch Container

This motor oil change guide was written specifically for a 2001 Pontiac Grand Prix GTP sedan equipped with the General Motors L67 3.8 Liter 3800 Series II V6 Eaton M90 supercharged engine.

Owners of other L67 engine equipped vehicles including the Buick Park Avenue Ultra, the Buick Regal GS, Chevy Impala SS, Monte Carlo SS, Holden Commodore, Monaro, Olds Eighty-Eight LSS, and the Pontiac Bonneville, may also find this guide useful.
First gather a floor jack, jack stands, a used oil catch container, 4.5 quarts of new oil, a new oil filter, a 15mm wrench, a funnel, and an oil filter wrench.
Warm up the engine for a few minutes so that the old oil will flow out quickly and to suspend any pollutant particles that are inside the crankcase. Once it reaches operating temperature, switch off the engine.

15 MM Metric Socket

Engine Oil Drain Bolt
Now you can raise the car using the floor jack and then place jack stands under the car as a safety backup. The oil drain plug is located on the bottom of the oil sump pan and was marked with yellow paint on my car. Remove the oil filler cap, place the catch container below the car and remove the oil drain plug with a 15mm wrench or socket. Go take a break and let the old engine oil drain for a few minutes. This would also be a good time to perform an Eaton M90 Supercharger Oil Change if you haven't before.  

Engine Oil Filter
Once all the old motor oil has been drained out of your GM 3800 L67 V6 engine, you can replace the oil drain bolt, and remove the old oil filter by hand or by using an oil filter wrench. Lube up the new filter's rubber o-ring with some new oil. Some of the oil filters that will fit the L67 include the Purolator PureONE PL10111, Purolator L10111, and the Fram PH3387A. Wipe off the oil filter receptacle and screw on the new filter hand tight.

Loosening Oil Drain Plug

Old Mobil 1 10W30 Draining
With the oil drain bolt securely tightened by hand and the new oil filter in place, you can now remove the catch container, lower the car off the jack and put the funnel into the oil fill port. The 2001 Grand Prix GTP owner's manual calls for four and a half quarts of oil for which I have chosen Mobil 1 10W30 synthetic blend. Just put in 4 quarts of oil to start, then warm up the engine and check the level on the dipstick. Slowly add the last .5 quart until the dipstick indicates that the oil level is just below the maximum line. Then check under the car for any leaks, and you're done. Record the oil change details such as vehicle mileage and the date and put it in your glove box for safe-keeping. A good set of maintenance records can mean hundreds of extra dollars in your pocket if you ever sell your car.  

New Mobil1 10W-30

Fram PH3387A Oil Filter

Oil Filter Wrench


Old Jiffy Lube Oil Filter

Oil Filter Seat

New Oil Filter Gasket Lubed

Funnel In Crankcase Filler

Pouring In Mobil 1 10W30

Dirty K&N Air Filter
It's also a good idea to check your paper or foam air filter at each oil change and replace it if it's dirty. I changed out my stock air filter and air box for a K&N aftermarket filter that has a million mile guarantee. Click on the following link for my K&N Air Filter Cleaning Instructions.

IAT Sensor In Place

Intake Air Temperature Sensor


Revenir en haut
Visiter le site web du posteur

MessagePosté le: Mer 3 Juil - 06:50 (2013)    Sujet du message: Publicité

PublicitéSupprimer les publicités ?
Revenir en haut
Montrer les messages depuis:   
Poster un nouveau sujet   Répondre au sujet    Bienvenue sur GM3800Québec Index du Forum -> Discussion automobile -> Comment faire "How-To" & Infos -> How-To - Comment faire Toutes les heures sont au format GMT - 4 Heures
Page 1 sur 1

Sauter vers:  

Index | Panneau d’administration | forum gratuit | Forum gratuit d’entraide | Annuaire des forums gratuits | Signaler une violation | Conditions générales d'utilisation
Powered by phpBB © 2001, 2005 phpBB Group
Traduction par :